Flinken Based Coat

Flinken Based Coat

Fliken based coat mortar is produced according to the requirement of BS EN 998-1: incorporating standardized binder, well graded silica sand, water retention ability addituve for all tyes of brick and block rendering laying and floor screed application.

Product Description

 
ADVANTAGES
 
  • Economical-saves time and money.
  • Quality assured Mortar mix.
  • Simple to use. No gauging of materials. Just add water.
  • Well selected of aggregate size to optimise the brick-lay process.
 
MIXING GUIDE
 
1. Mix one bag (40kg) of FLINKEN BRICK-JOINT with approximately 8-9 litres of clean water.
2. Mix continuously 3-5 minutes until a uniform paste is achieved and ensure the mix is from lumps.
3. Placing should be completed within 60 minutes after start of mixing.
 
TECHNICAL DATA
 
Appearance
Grey
 
Binder
Ordinary CMS Cement
 
Filler Material
Graded Silica Sand (<4mm)
 
Auxiliaries
Additives to improve open time and adhesion
 
Wet Powder Ratio
0.23-0.25 (8-9.2litre)
 
Wet Density
1700-1800kg/m3
 
Flexural Strength
>3N/mm2
 
Compressive Strength
>25N/mm2
 
Adhesion Strength
>0.5N/mm2
 
Pot Life
Up to 60 minutes
 
Coverage (approximation)
can brick joint 60-70 bricks