Pentens T-100 Water-based PU Bituminous Waterproofing Membrane

Pentens T-100 Water-based PU Bituminous Waterproofing Membrane

PENTENS T-100 is a specially produced PU bituminous waterproofing compound for use on both internal and external surfaces. It will bond perfectly to almost any surface such as concrete, masonry, metal, and timber. It may be applied to new or existing structures and will bond to a damp surface. It can also be mixed with sand, to form a mortar of any desired consistency.

Product Description

 
Uses
 
To provide a better water and vaporproof in complicating application surface compare to membrane-type and ensure better integrity between applied surfaces and waterproofing coating.

Areas of application include:
 
  • Floor slabs
  • Patios, terraces and balconies
  • Bathrooms
  • RC gutters and planter boxes
  • Swimming pools and water tanks
  • Basements and fountains
  • Retaining walls
 
Advantages
 
  • High elasticity
  • Will bond to almost any surface
  • Does not run or creep under any heat
  • Resists a wide range of acids and alkalies
  • Can be applied to a damp surface
  • Odourless and produces no fumes
 
Applications
 
Surface Preparation
All the surfaces must be clean, free from grease, oil, laitance, and remove all the dirt and contaminants, which might affect adhesion. The impurity outside the structure body should be cleaned thoroughly.
 
Application
Substrate should be primed with a mixture of PENTENS E-10-A and PENTENS E-10-B. Brush on at the approximate rate of 0.2 kg/m². On areas exposed hot drying winds. 2 to 3 thin coats of paint may be more successful than 1 thick coat. For indoor areas, it is recommended that allow approximately 30 minutes or after the primer becomes tacky then apply T-100.

With brush, roller, or spray method apply the first coat of PENTENS T-100 on the application surface. The first coat should be applied in one direction only. If possible the second coat should be applied at right angles to the first. Leave to cure for approximately 8 hours before applying second coat.
 
Safety
 
  • Minimum ambient and substrate temperature is 5°C.
  • Never apply more than 1 kg/m² of PENTENS T-100 in one single layer.
  • Apply only to clean, sound substrates where surfaces should be well dampened but free of surface water and leaks.
  • Thoroughly agitate contents before use.
 
Technical Data
 
Appearance
Liquid
 
Color
Dark brown
 
Consumption
5 kg/m2
 
Application Temperature
8 0C ~ 40 0C
 
Shelf Life
12 months when unopened and undamaged
 
Packaging
20 kg, 200kg/pail
 
Storage Condition
Store in a dry cool place